Featured Deal 1

$250 OFF

Any Complete Home Comfort Heating & Cooling System

With Coupon. CAN be combined
with coupon #4

Featured Deal 2

$100 OFF

Any Furnace Installation

With coupon. CAN be combined
with coupon #4

Featured Deal 3


Service Call Upon Repair

With coupon. Cannot be combined with any other offer

Featured Deal 4


Humidifier Plus FREE Honeywell Programmable Digital Thermostat with any new Furnace Installation

With Coupon. CAN be combined
with coupon #1 & #2

HL 180 to 600

HL 180 to 600

Split System 4 Pipe Condenser (HL) 15 to 50 Ton

These split system air conditioner models are completely assembled, piped, and wired at the factory to provide one-piece shipment and rigging. Each unit is pressurized with a holding charge of R-22 for storage and/or shipping.

The compact design, clean styling, and quiet operation make these condensing units suitable for almost any outdoor location. On rooftops, because they weigh much less than a single package unit of similar capacity and are much easier to rig and support. At ground level, because their ample sub-cooling capacity allows them to be located 60 feet below the evaporator coil.

All Sheet metal parts are constructed of commercial grade (G90) galvanized steel, powder-paint coated to withstand a 750-hour salt-spray test.
A complete line of evaporator blower units is offered to meet your precise capacity and air-handling requirements.

Product Description

Special Benefits

  • Built for efficient operation, long life, and moderate installation costs.
  • Exceeds an Ashrae 90.1 – 1999 energy standard.
  • All units have matching Coleman upflow, downflow, or horizontal coils for non-furnace installations.
  • Offered in 208/230, 460, and 575 voltages are easy to handle. They have base rails with forklift access and rigging holes.
  • Low ambient operation to 40°F is standard, and accessories for 0°F low ambient operations are available.
  • Installation time and costs are reduced by easy power and control wiring. All units are factory wired, piped, charged, and tested prior to shipment. Factory-installed options further reduce installation costs.
  • Electric utility knockouts are provided on unit side and bottom for easy connections.
  • Full-perimeter base rails are permanently attached to provide a solid unit foundation and fork lift access. Compressor is internally protected against high pressure and temperature.
  • Grooved copper tubes and enhanced aluminum fin construction improve heat transfer.
  • Permanently lubricated condenser and evaporator fan motor bearings need no annual maintenance.
  • Coil guards and crankcase heaters are standard.
  • Hot gas bypass, low ambient VFD phase monitor and pump-out options are available for field installation.

Additional information

Nominal Capacities

180 – 600 MBH


9.7 EER


Compressor – 5 year, Parts – 1 year


There are no reviews yet.

Be the first to review “HL 180 to 600”

Your email address will not be published. Required fields are marked *